Security Ranger III Betriebsanweisung PDF herunterladen (Seite 90)

Initial Setup

1. Install the battery.

The Lithium-Ion (Li-Ion) battery is shipped detached

from the unit. Insert the battery at the bottom of the

compartment first so the connector on the battery makes

contact with the pins in the battery compartment.

Using the flat end of the stylus or a coin, turn the latch

located above the battery clockwise until tightened. As

the latch is turned, the battery levels in the case.

2. Attach the hand strap, starting at the bottom.

Push the clip of the hand strap into the hooks on the battery door at the bottom of the handheld at a 180 degree

angle until it snaps into place.

Fold the top clip of the hand strap backwards so that it can be pushed into the top hooks of the handheld.

Pull up on the strap and push the clip into the top hooks at a 180 degree angle until it snaps into place.

The hand strap is now securely attached.

MAKE SURE TO HOLD EACH CLIP STRAIGHT, PARALLEL TO THE HOOKS, AND PUSH IT IN AT A 180 DEGREE ANGLE TO

ENSURE PROPER INSTALLATION.

3. Screw on the external antenna (p/n 66238-007). If the handheld is not equipped with a radio, skip to step 4.

4. Charge the battery.

The power supply that ships with the handheld has four international plugs. Connect the appropriate plug to the

power cord and attach to the power supply.

Plug into an electrical outlet and plug the barrel end of the power supply into the unit.

The battery can also be charged using the docking station.

ORION® Automated Meter Reading System for Trimble® Ranger 3

Page 90 February 2013

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 123 124

Keine Kommentare

Security Ranger III Betriebsanweisung Seite 90