Security Ranger III Betriebsanweisung PDF herunterladen (Seite 115)

ROUTE MEMORY STICK

Initializing the Memory Stick

The memory stick must be initially matched to the handheld

before a route can be loaded.

NOT:N If you need to change the handheld Device Name,

change the Device Name before you initialize the

memory stick for the handheld.

1. Insert a blank memory stick into the USB port at the

bottom of the handheld.

2. A message displays asking if you want to "initialize"

the memory stick.

Tap Yes to initialize the memory stick.

Incorrect Memory Stick

Each memory stick is prepared for use with a single

handheld. A memory stick that has been initialized with a

handheld cannot be used on another handheld.

When you insert the memory stick into the USB port at the

bottom of the handheld, a message displays to alert you that

the memory stick you are attempting to use was prepared for

another handheld as shown here.

Tap OK to close the screen and contact the reading data

management operator to secure the correct memory stick.

Wireless Load and Unload

The Trimble Ranger 3 supports wireless route load and unload procedures. For complete information, refer to the document

ReadCenter Wireless Network Setup (RDC-I-01-EN).

Installation & Operation Manual

Page 115 February 2013

1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 123 124

Keine Kommentare

Security Ranger III Betriebsanweisung Seite 115