Security Ranger III Betriebsanweisung PDF herunterladen (Seite 71)

Programming an ORION ME Gas Endpoint

NOT: N Before beginning, make sure the IR programming cable is connected and the IR COM port is set correctly. Refer to

"Settings for Program & Quick Read" onpage86 for additional information.

Programming an ORION ME gas endpoint is performed on the ORION ME IR screen. The steps below are specific for gas

endpoint programming. For additional information about the screen, refer to "ORION ME IR Programming" onpage48.

1. From the ORION ME main menu, tap ORION ME IR Programming.

Result: The ORION ME IR screen is displayed.

2. Align the read head of the IR cable to the gas endpoint. Then tap Read.

Result: The reading and serial number ll and the bar at the top of the screen changes to the endpoint type. In the example

shown, the endpoint is ORION ME IR: Gas Integral.

Figure 124: ORION ME IR screen before reading

Figure 125: ORION ME IR screen after reading

3. Tap the Change DC button.

Result: The Gas Drive Circle screen is displayed.

4. Locate the Drive Circle for the gas endpoint.

• Use the selections in the top half of the screen

to filter the list on the bottom by choosing

Integral or Remote, and choosing the Units,

Dials and Res (resolution).

• Or just scroll through the list to find the drive

circle for the endpoint.

5. Tap the drive circle for the gas endpoint.

Figure 126: Gas Drive Circle screen

6. Tap in the Pressure eld. Use the keypad to enter the pressure factor.

Result: The pressure you entered is displayed on the Drive Circle screen.

7. Tap Direction. Then select the direction for the drive gear.

Result: The direction you selected is displayed on the Drive Circle screen.

Installation & Operation Manual

Page 71 February 2013

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 123 124

Keine Kommentare

Security Ranger III Betriebsanweisung Seite 71