Security Ranger III Betriebsanweisung PDF herunterladen (Seite 86)

SETTINGS FOR PROGRAM & QUICK READ

When using Program & Quick Read or the ORION endpoint utility, it is important to make sure the COM (communication)

ports are set correctly for the hardware connected to the handheld.

The internal technology on the handheld uses COM 7. Technology connected to the nine-pin serial port uses COM 1. The built

in GPS uses COM 2. Sample settings of different configurations are shown below. For a complete list of valid COM ports, refer

to "Valid COM Ports" onpage112 in the Appendix.

NOT: N Adjustments to the COM ports should be made only with the assistance of Badger Meter Technical Support.

Changing a COM Port Setting

1. From the ORION endpoint Technology Selection

screen, tap Settings. Refer to "ORION Endpoint

Utility" onpage46 if you need help.

Result: The Settings menu opens.

NOT: N If the handheld has an internal ORION

ME transceiver, the transceiver firmware

version is displayed on this screen as

shown in Figure 156.

2. Tap to select the technology and view available

COM port setting options.

3. Tap to select the COM port or tap Cancel to return

to the Settings menu.

4. To Add Log File Header (optional), tap to select the

check box.

5. Tap Save to save any changes. Tap Back to exit the

screen without saving changes.

Figure 156: Sample settings for handheld with internal ORION ME

transceiver and IR optical cable (attached via serial port)

Figure 157: Sample Settings screen for handheld with internal

ORION CE receiver, with ORION ME transceiver (attached via USB)

and IR optical cable (attached via serial port)

Figure 158: Sample Settings screen for handheld with internal

ORION ME transceiver and ORION CE receiver (attached via

serial port)

6. Exit the software application and re-enter to ensure the COM port settings are active.

NOT:N If the COM port is not set correctly, the hardware technology does not display on the account read screen.

ORION® Automated Meter Reading System for Trimble® Ranger 3

Page 86 February 2013

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 123 124

Keine Kommentare

Security Ranger III Betriebsanweisung Seite 86