Security Ranger III Betriebsanweisung PDF herunterladen (Seite 44)

PROGRAM & QUICK READ

Program & Quick Read is used to perform a number of functions on ORION endpoints and touch modules. The most common

uses of Program & Quick Read include:

• Reading an endpoint or touch module (outside of the route reading process) when troubleshooting or testing at a

customer site.

• Reading one or more endpoints or touch modules prior to installation, to verify that the endpoints or modules are

working correctly.

• Clearing a tamper and reprogramming the odometer (RTR only) after the wire has been repaired.

• Testing a newly installed endpoint.

• Performing meter testing at the meter shop.

• Gathering a final reading from a meter.

NOT: N The handheld does not store Quick Reads and

cannot send any Quick Reads back to the reading

data management software.

Accessing Program & Quick Read

1. Access the ORION Field Application and navigate to

the Main Menu. If you need help, refer to "Program

Startup" onpage9 and follow the steps to access

the Main Menu.

NOT:N You do not need to have a route loaded to

access the Program & Quick Read software.

2. Tap Program & Quick Read.

Result: The Program & Quick Read Main Menu opens as

shown in Figure 76.

Figure 75: Main Menu

Two options are available on the Program & Quick Read Main Menu.

VersaProbe Opens the VersaProbe quick read software

application. Refer to page 45 for

instructions.

NOT:N For additional information about

VersaProbe, refer to "VersaProbe

Reads" onpage20.

ORION

Endpoint

Utility

Opens the ORION Endpoint Utility for

programming and quick read for ORION ME

and CE endpoints. Refer to page 46 for

instructions.

Figure 76: Program & Quick Read Main Menu

ORION® Automated Meter Reading System for Trimble® Ranger 3

Page 44 February 2013

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 123 124

Keine Kommentare

Security Ranger III Betriebsanweisung Seite 44