Security Ranger III Betriebsanweisung PDF herunterladen (Seite 51)

1. Double-tap the reading in the box to the right of

the Reading eld.

Result: The current reading in the eld is highlighted.

Figure 86: RTR Reading field

2. Using the handheld keypad, enter the RTR odometer value in the Reading eld.

Result: The inside of the reading box turns pink (Figure 87) to indicate a new value is entered in the eld but not yet

programmed.

Leading zeros are not required, however it may be helpful to enter leading zeros as visual confirmation. Only seven

digits can be entered when programming an endpoint, regardless of the meter size.

3. Align the optical read head of the IR cable with the ORION ME endpoint IR port and tap Program.

Result: The new value is programmed and the reading box is no longer pink. See Figure 88.

Figure 87: New reading is entered

Figure 88: New reading is programmed

NOT: N When programming an endpoint after clearing a tamper, verify that the programming and wire splicing were

successful. Tap ORION ME RF Quick Read - Single and tap Start Reading to perform a Quick Read on the endpoint.

If the endpoint still reports a tamper, check the wire splices, repair as necessary and repeat the programming

procedure above.

It is unnecessary to Stop an endpoint before fixing a tamper. If an endpoint has been stopped,

tapping Start clears the historical interval data (profile data) and places fixed mode endpoints

into mobile mode. Endpoints in mobile mode may not revert to fixed mode for up to 48 hours.

Installation & Operation Manual

Page 51 February 2013

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 123 124

Keine Kommentare

Security Ranger III Betriebsanweisung Seite 51