Security Ranger III Betriebsanweisung PDF herunterladen (Seite 108)

Connecting an External Mobile Transceiver or Receiver

For handhelds configured with an internal transceiver or receiver (Config 1 and Config 2 on previous page), one external

ORION ME mobile transceiver or ORION CE mobile receiver can be connected to read ORION endpoints.

1. Place the magnetic mount antenna on the vehicle roof. Ensure that the free area around the base of the antenna

equals the antenna height.

NOT: N The antenna must be at least two feet away from other antennas and the cable must be in good condition.

2. Press the green power key on the handheld keypad.

3. If the handheld has an internal ORION ME transceiver, connect an ORION CE mobile receiver using the receiver's

communication cable. Plug the communication cable into the top of an ORION CE mobile receiver and insert the

nine-pin serial end into the port at the bottom of the handheld.

If the handheld has an internal ORION CE receiver, connect an ORION ME mobile transceiver using the transceiver's

communication cable. Plug the smaller end of the communication cable into the top of an ORION ME mobile

transceiver and the larger end into the USB port at the bottom of the handheld.

NOT: N You can also connect an external ORION ME mobile transceiver to a handheld with an internal ORION ME

transceiver, or connect an external ORION CE mobile receiver to a handheld with an internal ORION CE

receiver. The external connection increases the radio range for meter reading.

4. Connect the cable from the magnetic

mount antenna to the RF connector

at the top of the mobile transceiver

or receiver and hand tighten so the

connection is secure.

5. The mobile transceiver and receiver

require a DC power source. Plug the

transceiver or receiver DC power cable

into the bottom of the transceiver or

receiver and plug the other end into the

vehicle's interior DC power source (utility

source or cigarette lighter).

6. Switch on the mobile transceiver or

receiver connected to the handheld.

NOT:N Make sure to switch on the

mobile transceiver or receiver

connected to the handheld

before starting any ORION

software.

Handheld with

External Connection

DC Power Connector

Magnetic

Mount

Antenna

ORION

Transceiver or Receiver

Communication Cable to

USB or Serial Port

Magnetic

Mount

Antenna

Cable

Refer to the installation documents ORI-I-80-EN (transceiver) or ORI-I-75-EN (receiver) for status indicators and

replacement parts.

7. Start the ORION Field Application software. For instructions, refer to "Program Startup" onpage9.

8. Navigate to the hardware settings and set the appropriate COM ports. Refer to "Hardware" onpage38 in the

Utilities section.

IMPORTANT

ONLY ONE EXTERNAL MOBILE TRANSCEIVER OR RECEIVER SHOULD BE CONNECTED TO THE HANDHELD. CONNECTING

MORE THAN ONE WILL REDUCE SYSTEM PERFORMANCE.

ORION® Automated Meter Reading System for Trimble® Ranger 3

Page 108 February 2013

1 2 ... 103 104 105 106 107 108 109 110 111 112 113 ... 123 124

Kommentare zu diesen Handbüchern

Keine Kommentare

Security Ranger III Betriebsanweisung Seite 108

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sicherheitskameras Security Ranger III